BrainModular

I am facing a little problem with my interface builder.

I try to show a led in the Interface Builder when a rack is on, but in the usine rack module the on-off cannot be connected... Is there another way to do this?

Thank you very much for the help...

Benjo

hi,
there is an enabled outlet..you could use this..

Looks good. But this only works for a patch? . How can I Show the status of the rack?

Create a new rack and add a rack settings module, select the rack number and use the on outlet

But there is no on outlet. In the configuration window it is, but can not be connected...

sorry i dont understand..u need the status of a rack? if its enabled then its on, isnt it?

Where can I get that rack settings module you are using above? As you can see,in my rack settings there are less in and outlets....

Uh nooooo!! Sorry to waste your time 🤣... Didn't know that....

Thank you!!!

not to worry..

nay-seven wrote:Create a new rack and add a rack settings module, select the rack number and use the on outlet

nay, is there a difference between on and enabled besides the outlet?