Looking for a simple metronome solution
-
bsork
- Site Admin
- Posts: 1334
- Location: Asker, Norway
You can create simple metronomes in different ways - the simplest would of course be to use two samplers: one for the accent/downbeat, and another for the beats.
Another quick way to add accents, is to connect a synchro module to the pitch inlet via A=B and A*B:
synchro.bar pos -> A=B.A (set B=1) -> A*B.A (set B to eg 12 for an octave up) -> sampler.pitch
I tried something similar with gain, but it didn't work very well...
I too remember that Vincent had created a nifty little metronome patch - maybe it should be in the add-ons?
Another quick way to add accents, is to connect a synchro module to the pitch inlet via A=B and A*B:
synchro.bar pos -> A=B.A (set B=1) -> A*B.A (set B to eg 12 for an octave up) -> sampler.pitch
I tried something similar with gain, but it didn't work very well...
I too remember that Vincent had created a nifty little metronome patch - maybe it should be in the add-ons?
Bjørn S
-
antwan
- Member
- Posts: 164
Hi nofish,
here's my suggestion. only one sampler needed and separate accent and normal clicks:
so add a sampler, into the file list first add the accent then the normal click sounds. set the sync mode of the sampler to "play button".
add the required audio outputs to the the sampler.
then add a Global Synchro module.
then add a > module in between the two.
then make the following connections:
From bar led (Synchro) to play (Sampler)
From bar pos (Synchro) to A (>)
From Out (>) to file (Sampler)
Set the B port of the > module to 1.
Activate the patch and there you go.
antwan
here's my suggestion. only one sampler needed and separate accent and normal clicks:
so add a sampler, into the file list first add the accent then the normal click sounds. set the sync mode of the sampler to "play button".
add the required audio outputs to the the sampler.
then add a Global Synchro module.
then add a > module in between the two.
then make the following connections:
From bar led (Synchro) to play (Sampler)
From bar pos (Synchro) to A (>)
From Out (>) to file (Sampler)
Set the B port of the > module to 1.
Activate the patch and there you go.
antwan
-
kara
- Member
- Posts: 106
- Location: France - Bretagne
- Contact:
See the add-on section
I've just uploaded a simple metronome
k
I've just uploaded a simple metronome
k
Free samples-vsti's-artist hosting at www.kara-moon.com
Music forum at www.kara-moon.com/forum
Did I mention how great Usine is ?
Music forum at www.kara-moon.com/forum
Did I mention how great Usine is ?
-
nofish
- Member
- Posts: 114
antwan,
honestly I didn't quite know exactly what this patch does but since I usually don't need to do that kind of patching I don't care too much...
Anyways it works like a charm. exactly what I was looking for!
Maybe you should put it in the AddOns section.
Thanx a lot.
honestly I didn't quite know exactly what this patch does but since I usually don't need to do that kind of patching I don't care too much...
Anyways it works like a charm. exactly what I was looking for!
Maybe you should put it in the AddOns section.
Thanx a lot.
