Page 1 of 1

Posted: 06 Mar 2015, 18:58
by sephult
Hello Everyone!

I am running into some strange issues with the For loop.
Up until this point I have used bigger sized messages, and it seems at this point there is a bug in the For loop.
If I set the lngthMidi equal to 1 it should essentially be the same as below:

Code: Select all

for i:=0 to 0 do begin

end;
However, even though it is supposed to be only 1 iteration of the loop it looks like it is running 2 iterations of the loop.


Curious I was wondering if anyone else has run into this?

Posted: 08 Mar 2015, 16:23
by sephult
I did get around this I had to use an additional, conditional statement with a break...it just seemed odd that this would present 2 iterations.