Midi Filter help

[gurulogic]

I'm having an embarrassingly hard time figuring out what should be a relatively easy midi filtering task.

I need to filter out CC# 94 only on channels 5&6, while at no point interrupting the flow of other MIDI data on these channels, so simply inserting a stop module to interrupt the MIDI flow when channel # + CC# =B is not an adequate solution, and I'm scratching my head trying to figure out how to patch the MIDI filter module to work as a notch filter.
Should be easy enough.. Right?

[nay-seven]

the Midi filter module let you select one type of message , not a specific controller
use the Midi Multi Filter module for this

[gurulogic]

But the Midi Multi Filter does not allow the selection of specific channel to filter the one type of message from?
Oh wait, I think I see what to do. I need to use the Midi Filter module to choose a specific channel to send to the Multi Filter module.
Ok thanks, I will check if this works..

[gurulogic]

Ok, this works.. but seems an overly complex amount of patching for what I am trying to do. Unpack Sripts >>> in the patch are for remapping the two filtered CC's
(edit, found my problem)

[nay-seven]

You can delete the unpack modules and use the outlet value out of the Midi multi filter ?