Using Usine with the Dave Smith Tetra

[noise2sine]

Hello,

I'm using this synth which is mainly controlled by Usine (a lot of fun). The preset are organized with program numbers and banks. When i'm using the creat midi message module, i can change the program numbers using the program change option. But I didn't find a way of changing the bank number and the program numbers ? how can i do that ?


Cheers

[nay-seven]

hello
generally, bank select message are send with CC 0( msb ) and 32 (lsb )
you can refer to the midi implementation of the Tetra to find good values..
use 2 or 3 ( if you add a program change ) create midi module and maybe an unpack script behind could be useful too

there's also the sys ex solution ( there 's a module for that too in Usine )

[ethnix73]

Commonly, bank change is done with CC0 and CC32:

CC0 (0) + CC32 (1) should select the second bank...

But it may vary from synth to synth

[noise2sine]

Thanks i will try that, and let u know.

Thanks dudes

[noise2sine]

Hello,

I have tried what u said , with unfortunatly no success. i must add that i'm very bad with midi understanding.... I have tried to read the manual, i couldn't find any information that i could understand .... Do u think it would be possible to have in the add on section a simple patch allowing those actions like changing program,subbank,bank ..... ( I will play on sunday help.....)

Thanks a lot Usiners

[bsork]

I've taken a quick look at the manual, and wonder what "MIDI Parameter Receive" mode you're using. You can choose between All, NRPN and "normal" CC. If I understand the manual correctly, you should be able to select banks by sending CC no 32 with a value between 0 and 3 if the receive mode is All or CC.

Or what about putting all the programs you use into one bank?

[noise2sine]

Thanks for yr attention Bsork !

So i will use : a create midi message set on "CONTROL CHANGE" with the "code 1" set to 32 the "code 2" set between 0 and 3 ? and for the "PROGRAME CHANGE" an another create midi message module ?

[ethnix73]

Yes, you can use the same button for the two "create midi message" module. I think you have to put a "wait one cycle" module before the "create midi message" module sending the program change....

[magickz]

Hello,

I'm using this synth which is mainly controlled by Usine (a lot of fun). The preset are organized with program numbers and banks. When i'm using the creat midi message module, i can change the program numbers using the program change option. But I didn't find a way of changing the bank number and the program numbers ? how can i do that ?


Cheers

I am trying now the same with DSI Mopho. But still new to this. Would you mind to have me look into your patch to learn from you? Especially I do not understand yet how to use the NRPN correctly.