BrainModular

forget if too complex, but i spent time on another gfx nodal system wich allow to swich on/off any module, and found that can be handy in
several cases . (in this one it's by right click on header = toggle on off)

ie you got many osc data send and want to quick temporary swich some of them off but send input is wired , have to unwire then rewire.
or to debug stuff in a patch 'muting' some flow paths ect..

Funny, I actually just was doing some stuff as an example earlier.

In this case couldn't you just start building with Pass events to do your disconnects, etc?

I had built a few patches where two sound/sequencer generators could choose to bypass, or flow through just by putting a Pass event and wiring a switch. I know it's not feasible to put one for every wire...but in critical wires or spots it might be a good thing to always put?

-S

yut's never drastic in usine anyway^^, we can always patch some pass event flow or subpatch the stuff and add a "patch on off" yes , it was more let's say "daily handy/convenient sugg ^^ i took just one exemple but i think there are many. and that's the problem patching with other software, you spot the nice things of each^^, don't get me wrong senso on the other side usine has MANY MANY stuf the other has not

Yes it's complex to implement it.
But I'll think about it.
The main pb is that it will add an inlet on every modules and it's not memory free...