Hi everyone.
I know i should 'RTFM', but it's a big manual, and I haven't gotten this far yet.
I have 8 speakers in my studio I'm running from a Behringer UMC-1820. I have my studio monitors plugged into the main outputs (1+2) and smaller speakers fed from the other 8 mono outputs. The smaller speakers aren't getting any signal though. Is this because I'm running the free version?
The smaller speakers are working ok in Logic Pro.
audio outputs 3-10 not receiving signal
-
cmodica
- Member
- Posts: 616
- Location: Pélissanne
- Contact:
Hi.
You should first create a device with all the output you want to use. So in your studio setup you should connect your main output plus your 8 output for your small speakers.
After you add your device to the output section of your track.
You should first create a device with all the output you want to use. So in your studio setup you should connect your main output plus your 8 output for your small speakers.
After you add your device to the output section of your track.
