]]>
Thank's Nay!
Statistics: Posted by manecante — 12 Oct 2010, 15:24
]]>
here an example
on this one , if preset < 5 the bit crusher patch is turned off ( off course you're right about using A<=B )
Statistics: Posted by nay-seven — 12 Oct 2010, 08:08
]]>
i also realised that i should put a A<=B module instead of the A<B, otherwise the "split" number is ignored.
There is also a strange behaviour when i am moving the button of my controller if i am in the patch mentionned above, usine switch in the patch where the "on" button (i try to control) is. And this is not very handy to check what is happening in the patch.
Statistics: Posted by manecante — 12 Oct 2010, 00:54
]]>
_ the midi hardware ( as you've done )
_ add a button to the create inlet of the first create midi module and press it
one think i've forget to say , sorry, you have to use toggle mode for the midi learn mode ( right click on the on button and remote mode toggle
you can also do a right click and choose find in remote panel to check it's correctly assigned
then, the midi send to usine module act as a midi hardware , sending midi informations directly in Usine ( you can check the blue led in the dashboard )
be also careful to connect the conductor after to avoid conflict or bad recall
Statistics: Posted by nay-seven — 11 Oct 2010, 23:34
]]>
does that mean that i need a midi controller to do a midi learn on the button then (no virtual possibility?)?
I tested it with my controller (and of course the midi learn is working) but not the patch, when i change the nb in the conductor it does not change the activation of the button...
maybe it is something with the "control change nb x" because i did not understand what that means in your patch, apart from that i think I reproduce your patch without errors..
Statistics: Posted by manecante — 11 Oct 2010, 23:02
]]>
midi to usine module is in modules/ inputs_outputs
Statistics: Posted by nay-seven — 11 Oct 2010, 20:48
]]>
@nay : i don't know that much about the "send midi to usine", and don't see how to do it.
Otherwise i thought about using the keylearn like this :
-make a keylearn on the on button
-make a patch on another track :
num outlet of conductor --- A>B-----switch---passIfChange---pressed inlet of keyboard (putting the nb of the key of my keylearn inside the keyboard)...But no success neither...
Statistics: Posted by manecante — 11 Oct 2010, 20:12
]]>
Statistics: Posted by nay-seven — 11 Oct 2010, 19:00
]]>
Statistics: Posted by senso — 11 Oct 2010, 18:53
]]>
Can i do this with midi learn?
Statistics: Posted by manecante — 11 Oct 2010, 18:48
]]>
]]>
]]>
Statistics: Posted by manecante — 11 Oct 2010, 18:30
]]>